Hauling an equipment trailer with your truck can be a convenient way to transport large or heavy loads. However, it is essential to think about safety first when doing so. This includes ensuring that your trailer lights and wiring harness are installed and functioning correctly.
Trailer lights make it easier for other motorists to see you, especially in low-light or inclement weather conditions. Otherwise, it could result in a collision. Your trailer, vehicle, and payload may be damaged, resulting in severe injuries or even fatalities. So, with that in mind, here are five essential trailer lights and wiring safety tips:
Use The Correct Wiring
Trailer wiring harnesses come in different types, so choosing one compatible with your tow vehicle and trailer is a priority. The wiring harness should have sufficient length to reach the trailer and lights without slacking. You want to prevent the wiring from dangling below the trailer where it could contact the road.
Connect The Harness Correctly
Follow the manufacturer's instructions when connecting the wiring harness to your tow vehicle and trailer. Before loading the trailer or car hauler, double-check that all connections are secure and that the wiring is not frayed or damaged. Frayed or damaged wiring must be replaced.
Test The Trailer Lights Frequently
Testing all trailer lights before hitting the road is crucial to ensure they function correctly. This includes the running lights, brake lights, turn signals, and license plate lights. Skipping this critical step can result in serious consequences, including receiving a traffic ticket with a hefty fine. Take a few extra minutes to test your trailer lights and avoid potential problems, especially when driving at night.
Keep The Wiring Harness Clean and Dry
Keeping the wiring harness clean and dry will prolong the lights' lifespan. Dirt and moisture can corrode the wiring harness and cause electrical problems. Additionally, waterproof connectors, electrical tape, or heat shrink tubing are recommended to seal connections effectively, guarding against moisture damage and potential short circuits.
Inspect The Wiring Harness Frequently
Inspecting the wiring harness frequently for any signs of wear or damage is essential. In case of any issues, we highly recommend immediate repair or replacement to prevent any electrical problems. Additionally, replacing burnt-out bulbs promptly is also essential. It is advisable to keep spare bulbs on hand to ensure you can make quick replacements while on the road.
Common Trailer Lights
There are several different types of trailer lights, but the most common are:
The 4-way flat connector
The 5-way flat connector
The 6-way round connector
The 7-way round pin connector
Hot Tip: Always ensure the wiring harness is compatible with the tow vehicle and wiring when choosing a trailer light connector.
Trailer Lights and Wiring Harness Kit
It is important to note that Federal law (49 CFR 571.108) mandates that trailers have stop lights, tail lights, turn signals, and reflectors. Additionally, 80-inch wide or wider trailers, or those 30 feet long or longer, require extra lights and reflectors. At Bigfoot Trailers, we prioritize safety above all else. Therefore, every trailer we deliver in the United States includes the legally required trailer lights and wiring. It easily connects to your vehicle. Then, you're ready to load and go.
Buy Bigfoot Trailers in Jacksonville, FL
Bigfoot Trailers delivers! As a factory-direct manufacturer, we service the entire Eastern United States with locations in Raleigh, NC; Philadelphia, PA; Mulberry, FL; Concord, NH; and by appointment with retailers in Fort Myers and Marianna, FL. Call toll-free (866) 764-8878 or contact us here for a free quote.